Case 312 wide front end needed

[Owarzecha]

Hello, I have a case 312 with the wide front end. Motor runs
strong but recently have issue and looking for new front
end. Not sure where something like this can be found?
Appreciate any help or if someone is looking to buy one of
these? I am located in Stacy Mn north of the twin cities.
Thanks for any suggestions.

 

[Cash4Toys]

Take the casting that is broke off, that is to say, remove the two bolts holding the bracket to the transmission case, then pull the pin from the axle strut pivot and take it to a good welding shop. they may be able to save it.
If so, the bushings are still listed on the Case parts list, and you can have a new pin made, if its wore out, which it more than likely is, and the slop is what caused the break in the first place.

 

[John Saeli]

Very difficult piece to find, but they will weld.

 

[Owarzecha]

I can take the bracket off to get welded but I am trying to figure out how what I believe your calling the axle pin comes out (see picture) how does this remove to take off front axle?

 

[Joe (Wa)]

G1046 Bracket - rear, radius rod pivot

Give this guy a call: Don L (507) 433-0073, He is near Austin MN.

Joe

 

[Owarzecha]

Well I finally got it all off, not the easiest task to say the least. The shaft looks fine but yes I probably need to replace this brass bushing on the inside. Thats going to be a pain to knock out I can tell as well.

 

[Owarzecha]

Where did you see the bushings for sale? I believe that I need a o6472 part number?

 

[chcase]

I would call Don L and see if he can locate one or take it to a good machine shop to be welded and new bushing put in.Will be cheaper if Don L can find a good used one.

 

[Joe (Wa)]

If you are referring to the front pivot bushing the p/n is O6472AB later changed to p/n A30090.

John Saeli (315) 585-9826 lists the bushing on his website.