(800) 853-2651
SHOP NOW

Case Clutch Disk

Yesterday's Tractor Forums
T

Tim M

Member
LOOKING FOR A NEW OR FAIRLY NEW CLUTCH DISK WITH A 10 SPLINE SHAFT AND 9 AND JUST OVER 3/4 WIDE DISK.FOR MY 1940 CASE V TRACTOR. OR SOMEONE TO PUT NEW PADS ON MINE. FOR RESTORATION PROJECT. WOULD ONE WORK OFF OF A CASE VAI OR VAO OR ANY V SERIES ?
 
The VA case has 9" 1 1/8" hub 10 spline. I can check to see if I have one available tomorrow or I can rebuild your disk if the hub and blank are good. Feel free to email me with any questions.
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top