Case d hydrolics

[hghrdnhck]

Anyone have a picture of a case d with hydrolics on it. I bought a pump that a guy said came off a d, but have no idea how it goes on.

 

[tomturkey]

take a look under the pto shaft at the back. Then search CIH parts site and look for the diagrams. gobble

 

[hghrdnhck]

There's no where for it to bolt on. Below the pto there's just a drain plug. I'm not sure how to post pictures of it

 

[Mathias NY]

Here is a picture of a factory pump on a "50 DO. If your tractor didn"t originally have a hydraulic pump, you will need a few other parts too.

The rear axle cover needs to be changed, a longer PTO shaft needs to be installed, and the operator platform needs to be modified. Also I believe the drawbar mount and drawbar need to be lengthened.

I bought the tractor in the picture for parts with the intent on moving the pump to my DO that runs. I"m still looking for motivation to make the swap...

 

[hghrdnhck]

Looks like I need the rear cover and extended pto shaft. I got the pump and lever. This is probably going to be hard to find. Thanks for the picture, at least I know how it goes on now.

 

[hghrdnhck]

You wouldn't want to sell your would you?

 

[Mathias NY]

Sorry, not for sale. Unless you lived in upstate NY, it would probably not be worth your while anyway.

 

[chuck machinist]

Try Ebay. I picked up a manifold ,starter , water pump and a drawbar clamp for my 411.You have to be vigilant, and keep looking. Something new every day!

 

[applein]

i have 1 with & 1 without . the hyd D is in the shop get ready for painting . hope this help you

 

[hghrdnhck]

 

[kennytractor]

You have to remove the entire rear plate and replace it with one for the hydraulic pump. Pretty sure it is the same as a DC.

Your platform will need changed and you will need a different PTO shaft.
Your drawbar will be too short