(quoted from post at 09:45:57 06/28/20) Good morning,
can anyone tell me where I can buy a Case DC oil pump spring?
I have looked around, but not found one. Mines is broken up.
I could also make for find one if someone can tell me the specifications.
Please let me know.
Thank you,
Scooter
Thank you for this info. Not trying to revive an old thread but just wanted you to know this info is hopefully going to help me fix mine this weekendGood evening,
I finished my spring tests and have the following information for anyone who needs a Case DC spring. This produced 30 psi for my system. I just finished shimming main and rods to max .002". I also resurfaced and lapped my relief plunger and seat.
The closes spring material I could find has a lower spring rate so the spring is different length that OEM.
Spring used is McMaster 9663K27. It is 20" long and $7.22 + shipping.
To make one you need a propane or small torch.
1. Use the torch and needle nose pliers to shape one end to be closed and ground flat. start at the end of the wire to begin bending and shaping. Use as little heat as possible. Quench end. Oil or water
2. Measure 3.5" of spring + one more loop needed to close the end and cut to that length.
3. Use torch and shape end to be closed and ground. Quench end. Oil or water
4. Stand spring on ends to make sure it stands up straight so the force on the plunger will be square.
The spring cap is harder to thread up because the spring is longer. Dont worry, the spring cavity and plenty of room left.
Good luck,
Scooter
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy