Case LA clutch discs stuck

ogema1912

New User
I'm finally getting down the the last components of my LA tear down. Tractor belonged to my grandfather and has been sitting outside unused for 40 years.

I split the tractor and the clutch discs are completely fused together. I'm wondering if there are any tricks to getting them apart? I haven't tried much aside from a few whacks with the hammer and chisel. But I don't want to damage the clutch material if it can be salvaged somehow.

Any comments are greatly appreciated. This forum has been fantastic getting me past a few sticking points with this being my first tear down.
 
Is it rusty ? If so its junk. Do whatever it takes to free it.
That clutch runs in engine oil but sitting 40 years it will
be rusty. Are u saying its a double disc clutch? Do you
have the pressure plate off? I have an LA and did not
think it had a double disc. Post a pic of your problem.
 

I didn't take a picture at the shop but here's a diagram. Not much visible rust on it but I can't get either plate off the disc. This is my first time into this style of clutch so there a chance I'm missing something that needs to be removed first I suppose.

mvphoto104193.png
 
Not sure where youre at on this ? Is the stuff on the floor
? U talking about 4485A plate being stuck ? Just smack it
with a big hammer.
 

Pull out on spring-loaded pin 1715 while rotating yoke 54 counter-clockwise to unscrew it from plate 4484.
A little oil on the threads might help you if it's sticky and gummy with old oil.
There's no need to disassemble the yoke, cone and collar from one another unless you find a problem with one of those parts.
I recommend that you use new lock washers when you bolt the clutch disc back to the flywheel.
Actually I would use new lock washers on any of it that I had apart.
 
(quoted from post at 02:57:37 04/05/23)
Pull out on spring-loaded pin 1715 while rotating yoke 54 counter-clockwise to unscrew it from plate 4484.
A little oil on the threads might help you if it's sticky and gummy with old oil.
There's no need to disassemble the yoke, cone and collar from one another unless you find a problem with one of those parts.
I recommend that you use new lock washers when you bolt the clutch disc back to the flywheel.
Actually I would use new lock washers on any of it that I had apart.
code:1:a494774aef]

Again, it looks like I missed an important step. It came apart quite easily once I had this step completed. Thanks for your help on this. I guess my impatience shows occasionally. If I just stopped and examined the problem a bit longer, I would have noticed that yoke was treaded on. The facing still will likely need to be replaced but atleast it's apart now. [/code:1:a494774aef]
 
Thats the problem with info without seeing the unit. Who
would know u dont know how to disassemble the unit. U
made it sound like it was stuck together which it very well
could have been sitting 40 years. So how is them discs
??
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top