Case sc Pto

Evanschuch

New User
So recently purchased a 1942 case sc. I went to replace the
mounting plate and guard on the pto, when I removed the old ones
the pto popped out and now I cant pop it back in or go in either
direction. How do I get the pto shaft to go back in? So I can shift and
operate properly. Please help if you have any knowledge its much
appreciated, thank you!
 
You have to pull the top cover off the transmission. Then up by the clutch, there are 2 covers to remove. When you get that far into it, you will see what needs to be done. Be very carefull when lowering the transmission cover back down! Shift forks must be engaged.There is a cover over the end of the PTO shaft inside clutch housing.

Can't remember if the front of the PTO shaft has a C-clip or a nut and cotter key. Those must be missing or the shaft would not have pulled out on you.

Beagle
 
Sounds like a big job, unfortunately Im not a mechanic or very good at that stuff so this will be very interesting. I do really appreciate the information though, thank you very much
 
Not a terrible job. Did one on a C Case out in a snowbank to get parts out last week. Took about 20 minutes.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top