farmall560

New User
just bought a case 220 it hydro drive but when i put in forward r reverse it want to jump sumtimes would my valve body b causing this
 
Make sure the high/low neutral lever between your legs is fully engaged, and staying engaged. Should be a little pin sticking out that locks the lever into each of the three postions.

also, don"t use anything in the hydraulic system except a good brand 15 40 or 20 50 engine oil. Thts what it was designed for. Hydraulic oil just doesn"t work well in them.
 
tl's advice is spot on. You would be wise to drain the hydraulic system completely and replace the fluid with a good quality 20W50 motor oil. Use nothing else.

The bulk of your problem has to do with the wear and tear on the linkage between your left hand and the actual spool in the travel valve. Small amounts of slop add up and that allows the spool do whatever it wants to. Keep in mind that while your hand moves quite a bit, the actual spool moves very little going in and out of the travel valve itself.

Pay close attention to the hole in the bracket welded to the bottom of the control lever as well as the arm that goes into that hole. The other biggee is the little ball coupler that joins the spool to the arm. You can remove that coupler and then use a hammer and very, very dull chisel to carefully close up the metal around the ball so that all play is eliminated.

This is a temporary fix. You may be able to get that coupler from McMaster-Carr online. I haven't sourced it as of yet but it's on my to-do list.

The more free-play you eliminate, the more precise your control will be over the movement of the travel spool. Don't overlook the travel lever itself where it enters the cast-iron bracket on the frame. Grab this rod firmly and try to move it around because there is a tension spring down there that will fight you while you are trying to determine how much play is in the rod and hole.

BTW, there is an Allen headed drain plug (very small) on the underside of the travel valve. Make sure you have a good Allen key that fits tightly into the plug and goes all the way in before attempting to turn it. This is the drain for the system. Remove this plug, remove the spark plug, use the key to spin over the engine and the oil will get pumped out into that bucket you put under there.

When the oil stops streaming out, put the plug back in. Fill the steel front-mount reservoir to an inch and a half below the top. If you have the plastic or metal rear-mounted reservoir under the battery, then fill it just to the bottom of the fill neck.. no more.

You should be changing this oil EVERY year, without fail.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top