cast centers

[Dieseltech]

Need to move some 1466 rear cast centers with the single bolt clamp wedge. What's the best way to get those wedges loose?

 

[CDN 400]

You will need a set of the horse shoes that came with the wedge locks and the two long bolts. One on each side of the hub bolted tight together so when one wedge comes loose it bottoms out against the horse shoe and pushes the other wedge out. Also you need a GOOD 7/8 12 point socket and an inch drive impact and a sledge hammer. I moved more than I can remember and keep a couple sets of those horse shoes on hand.

 

[Super B]

Need to move some 1466 rear cast centers with the single bolt clamp wedge. What's the best way to get those wedges loose?

This is Bert from Rivers & Bluffs I have what you need and could send it to you call Me 712-298-0289

 

[Dieseltech]

This is Bert from Rivers & Bluffs I have what you need and could send it to you call Me 712-298-0289

Thanks Bert, I'll let you know if I need it. Have a good weekend!

 

[Super B]

Thanks Bert, I'll let you know if I need it. Have a good weekend!

I don't have one of those tractors anymore, I would give it to you.

 

[BarnyardEngineering]

Supposedly you can hit DOWN on the top of the axle with a sledge hammer and the wedge will supposedly pop loose. Supposedly. In my experience, no dice. We beat and heat and drove pins in from the opposite side, nothing... Borrowed the wedge tool from the local dealer and it popped right loose in 1/2 a turn without much effort.