Caste bullet manuals

[Keith-OR]

I found a RCBS caste bullet manual #1, while I was going through my reload manuals. If anyone wants manual I will send it to them.
Send me your addy, my email is open.

Thanks
Keith

 

[RESLLS]

Keith I could sure use it. Can't find any .321 lead for my 32 Winchester special. Think I'm gonna have to buy a mold and cast some. I have about 20 lbs of lead, should last a while between that and my 3 45 Colts. I'll try the email. I usually can't get it to work though.

 

[Keith-OR]

my email is

[email protected]

 

[urbancase]

talking reloading, i do a lot of 12ga for trap shooting. anyway a gun shop i deal with a lot did a remodel and he had taken it over form a guy that started it back in the 70's. i bought a box misc reloading items and in there was a lyman bullet mold handle set in the box. i let it go to someone that can use it for the shipping cost or could pick up. just reply to this message.
thanks and good luck with your black powder fun.

 

[caterpillar guy]

Start asking around there is/was a guy down south I think around MS that they called the dentist made molds.

 

[caterpillar guy]

Older lyman reloading books show some pictures with numbers on them of tools and then if you look for the book SPG Lubricants Reloading Primer it has many loads for old black powder cartridges of many calibers and bullet weights. There is also the story of how it got started in mine. They could also point you in the right direction for molds or cast bullets. They are in MT around Columbus or Livingston area.

 

[Bill in Colo]

Little offtopic, but I could use some .228 bullets for my 22 Hipower 99 Savage
Thanks Bill