shaun wallace
Well-known Member
- Location
- Stith, Jones County Texas
What all has to come off or out to change clutch cable ? End broke off at pedal. Looks like not much room at valve end
I will be watching the replies as I need to replace the cable on a 2390!What all has to come off or out to change clutch cable ? End broke off at pedal. Looks like not much room at valve end
I'm not familiar but can you pull new cable through with old cable?What all has to come off or out to change clutch cable ? End broke off at pedal. Looks like not much room at valve end
I'm not familiar but can you pull new cable through with old cable?
What do you do at the valve end?I remove the dash then the console to get to the nuts on the end of the cable under the pedal. May be I am missing an easier way.
Struggle. I have several different brands of open end wrenches and from one wrench to another the angle of the open end sometimes is just enough different that by using one and then another that eventually I get the cable tight. Also I pop the plastic plug out and move the PTO cable out of the way.What do you do at the valve end?
Did you get the job done?What all has to come off or out to change clutch cable ? End broke off at pedal. Looks like not much room at valve end
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy