Hey guys, I was wondering if any of you fellers had any experience with a clutch sticking on the lil B? Got this lil jewel couple years back when the feller that owned it hired me to overhaul the steering box.(The ball bearings had become so wore they fell out there race and jammed up the worm so the steering wheel flat locked up on him.)Anyhows it had been used regular as a mower and my pa has used it regular for the same. The clutch wasnt right from the get go, not releasing when the peddle was pushed and if you hit both footbrakes suddenly it releases. I thought maybe with steady use she would loosen up but no such luck. I checked finger clearences and they are good, also gave her a small pump of grease up in the insp. port but that didnt help anything. I currently have a wc tore down in the shop and am a few weeks from gettin that put together but plan on splittin the B when done with that project and having a good look see. What I aint gettin is when hittin the brake pedddle and popping the clutch loose it will shift fine for a while then go back to stickin til the brake peddles hit again, what on earth can be causin this hang up- the throw out bearin goin bad? Should i just replace everything, press plate clutch and throw out bearing when shes split? Im leaning on total replacement but would value the opinion of any of you thats been into these lil Allis's. Thanks for any help, Sincerely, Hoss