coil

[McGuyver]

In a 12v conversion kit Bought through YT how many ohms would the coil be? .7-1.5 or 2.5-3?

 

[JMOR]

Any are suitable if you use the correct resistor with them. Typically the 12v kits come with 2.5 ohm coils for front mount distributors. Side mounts can use a 3 to 3.25(IC14SB) to maybe 4 ohm coils with no resistor at all.

 

[John P.]

The 12 volt negative ground Pertronix kit I put into the Oliver uses a 3ohm epoxy coil with no ballast resistor.

 

[Dell (WA)]

uh John?......since when did yer Oliver have a 4-nipple distributor with squarecan ignition coil??? .......respectfully, Dell