cold blooded 4020

T-Nason

Member
hey yall,
so im away quite a bit for my job (construction) anyway, dad was saying the 4020 has been getting harder to start the past few months. seems it needs a wiff of ether in colder weather. anyways, yesterday he says he was cranking it and it really took awhile for it to fire up. the starter was spinning fine and everything. is this a issue to worry about? my worst fear is my compression is low and its gonna need an overhaul. has probably 4500 hours on the last one as of now.
 
How cold is it there? Just plug it in. Be starting like summer time. I plugged the 560 in yesterday with block and pan heater And it started as soon as I touched the starter button. And u say 4500 hrs on rebuild , well that is half the hrs it should last. Diesels like to be warm to start good . they need to build heat from the compression in order to start. Yesterday was 28 F here.
 
Something to worry about? Depends on what kind of person you are.

Some people start wringing their hands if it takes an extra revolution to get the engine started. Others don't give a hoot if it takes a whole can of starting fluid to get it going in the morning.
 
all the above; i was gona say we had 4010 dad bought new in 62 did not need a rebuild till 12000 hours; but i realize everyones idea of maintenance is different; also engine warmup period.
 
Are you using a block heater? If its starting harder the colder the temps get, I would be plugging it in and warming the block before starting.
Done cattle chores for a guy for awhile if he needed me to when he was away. He had multiple tractors including a 3010 he didn't use all that much. If it wasn't plug in when it was cold, it always needed a little nose candy. One time, I needed to move it out of the way in pretty short order, and didn't have it plugged in. I had to use nose candy, and didn't think I was going to get it started. It started fine in warmer temps, ran ok, and didn't use any oil as I recall.
 
A weak pump and worn injectors will cause this,,how long has it been since they were worked over..I would start there..
 
A diesel motor is good till you can't get it started even if you pull it! I had a little Mazda diesel pickup. It never did use hardly any oil. I drove it till I finally couldn't even get it started whe it was 90 degrees outside, even with ether! I believe it had around 400,000 on it. Big trucks sometimes will last a million miles, but they are geared low and the motor doesn't turn over as many revolutions per mile as a gas engine.
They may have harder cylinders too.
 
My 3020 would not start unless it was 55 degrees . Put reman injectors in from John Deere and itll start at 0 degrees without being plugged in .
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top