Brad Buchanan
Member
I roll my toolboxes around on this floor so it is not too far O/T.
I have a concrete floor in my shop that is smooth enough to dust mop. It has never been sealed so it absorbs spills like atf, oil etc.
I have been researching floor coatings and found products ranging from $17 a gal to $400.00 for S/W epoxy. Euclid Chemical sells a product called Duraltex 1705/1805 which is an epoxy primer and surface coat for $450.00 for a 3 gallon set of each.
My dilemma is that the epoxy is great for vehicle traffic but I use the same shop for welding and torch work frequently.
Would I be wasting my money with the epoxy or would it stand up to that kind of abuse? The local dealer had no answers. I have about 1500 sq. ft. to coat.
Info., comments are welcome positive and negative.
Thanks,
Brad
I have a concrete floor in my shop that is smooth enough to dust mop. It has never been sealed so it absorbs spills like atf, oil etc.
I have been researching floor coatings and found products ranging from $17 a gal to $400.00 for S/W epoxy. Euclid Chemical sells a product called Duraltex 1705/1805 which is an epoxy primer and surface coat for $450.00 for a 3 gallon set of each.
My dilemma is that the epoxy is great for vehicle traffic but I use the same shop for welding and torch work frequently.
Would I be wasting my money with the epoxy or would it stand up to that kind of abuse? The local dealer had no answers. I have about 1500 sq. ft. to coat.
Info., comments are welcome positive and negative.
Thanks,
Brad