Cracked block

loweman56

Member
Bought a 8n from a guy...dont know much about these but am learning...is the block cast or is it steel.Have a small crack in side by starter...can i grind a small slot and weld???Thanks for helping me out!!!!..wished i would have seen this problem first!!!!
 

I don't know much about the little Ford tractors in particular, but I've seen quite a few engine blocks with small cracks around the starter opening that never caused any problem.

Unless it is causing you some trouble, I'd leave it alone...


Howard
 
I am not a Ford person, but I can tell you that most blocks were made of cast and the cylinders were machined out. It also depends on how big the crack is. You said it was small, it may be small now, but if you leave it alone without welding it, the engine's vibrations can make the crack bigger.

I hope I cleared some things up.
 
Do what Howard sujested, if you weld it drill a one eigth hole at to end of the crack ,heat the area, and weld with a nickle rod, one quater inch at a time, then ping with a ball peen hammer to relieve stress!

Good luck!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top