(800) 853-2651
SHOP NOW

Cross shaft for Ferguson plows

R

Richard Glenister

New User
I have a set of Ferguson 3-bottom plows. Last year I hit a stump that had been sheared by a dozer at below ground level and snapped the cross shaft. It measures 45 mm dia x 800 mm wide. Does anyone know of a salvage yard that might have one? They are apparently available in Britain but that's across the ocean.
Any suggestions?
Thanks in advance.
 
You must log in or register to reply here.

Similar threads

R
Ferguson plows
Replies
6
Views
772
Ray,IN
R
C
throttle linkage binding on rebuilt carb
Replies
8
Views
3K
crazylocha
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top