Cub cadet 7305 wheel bolt pattern

[Phill Tibbetts]

Not having any luck on the tractor thread so here is my question. Does anybody know what the bolt pattern diameter is for the 6 bolt hole rear rims for a 2003 Cub Cadet 7305? TIA

 

[Mule Meat]

Measure from center hole to center hole on the wheel.

 

[Phill Tibbetts]

Measure from center hole to center hole on the wheel.

I know how to do that but want to know if it is US or Metric. Hard to tell now half the stuff is metric and half US .

 

[oldsarge]

6 bolt????????????????????????????????????

 

[Jim.ME]

I know how to do that but want to know if it is US or Metric. Hard to tell now half the stuff is metric and half US .

Measure in either US or metric than convert the measurement to the other. Then you will have both US and Metric measurements to work with.

 

[NDIHC]

I know nothing about those tractors other than they have a 6 bolt pattern and are built by Mitsubishi. I don't see any dimensions published for the lug hole pattern measurement. Looks like you're going to have to measure it and convert to metric or SAE as required. I guess I'm no help! We used to have a set of bolt pattern gauges that were pretty handy for measuring lug hole patterns at a tire store where I worked.

 

[Mule Meat]

6 bolt????????????????????????????????????

Yes Cub Cadet used six lug wheels on the 7235, 7272, 7273, 7274 and the 7275. The compact tractors were built by Mitsubishi in 1996-1997.

Side note.. The two middle numbers were the HP rating for the tractors.

 

[Mule Meat]

I know how to do that but want to know if it is US or Metric. Hard to tell now half the stuff is metric and half US .

If you know how to do that. You should have no problems converting inches to metric or vise versa. Google can do it for you if need be.

 

[John Garner]

I've found it's much easier to measure outside-to-outside distance between a diametric pair of studs-or-bolt-holes and subtract the diameter of one stud-or-bolt-hole than it is to measure the distance between two estimated stud-or-hole centers.

 

[kencombs]

I've found it's much easier to measure outside-to-outside distance between a diametric pair of studs-or-bolt-holes and subtract the diameter of one stud-or-bolt-hole than it is to measure the distance between two estimated stud-or-hole centers.

Or, outside of one to inside of the other. No other math needed, and is pretty easy to do accurately with a digital caliper.

 

[EFV]

My CaseIH 275 compact measures at 6" C to C. If Cub is a Mitsu like mine could be the same .