cylinder identification

[jm.]

Need help in identifying two cylinders that came with a pallet of auction stuff. Green body is about
30 inches with maybe 3 1/2 bore then the od part starts on end of each rod is a 4 in round affair
about a foot long with diffrent holes of a pin. Attached a couple of photos maybe someone that
needs these because they are very specific just never have run across any just like these. appear to
be matched pair with hose crossing over . Anyone needs them send me a message they will be cheap.

 

[shaun wallace]

Thinking wing cyl for disc. Probably resealed some like that years ago.

 

[jm.]

You may be right I was thinking loader , where you could adjust the lift height but the holes may be for a disk as you say thanks

 

[super99]

I'm thinking more like a haybine or mower conditioner.

 

[rufus80]

Those are off of a disk. If you look through the holes you'll see a big spring inside for the flex.