D21 wide front

[Whiskey Bent]

Fixing up grandpa’s D21 slowly and I found that the front axle and spindle are bent. The center part is fine just need to find preferably a left side spindle with the cast tube. I believe that the 210 and 220 are the same? I know a lot of these were made into pullers and they probably built a light weight front for them, was hoping somebody had something laying around yet. Thanks guys

 

[paulsamwel]

Fixing up grandpa’s D21 slowly and I found that the front axle and spindle are bent. The center part is fine just need to find preferably a left side spindle with the cast tube. I believe that the 210 and 220 are the same? I know a lot of these were made into pullers and they probably built a light weight front for them, was hoping somebody had something laying around yet. Thanks guys

You might try the Unofficial Allis Forum on the web.Might get a response sooner there.

 

[DrAllis]

PULLOFF.com is the place to look under for sale or wanted. That is where puller parts are located.

 

[560Dennis]

check Wellerts AC equipment in West Salem ,Ohio

Check Chalkers in Southington Ohio

 

[Whiskey Bent]

Thanks guys I did post on pulloff.com