I have a D262 engine total rebuilt and the sleeves was in the correct hight, but after some years the sleeves star to sink again. I believe the flanges are worn out. The engine hade cost me a lot of money, sadly. lot af new parts are wasted.
Now i have find a Buda 273 with one broken piston and the cylinder head is broken.
The Buda 273 Engine block seems to be the same block as the D262 except the sleeves.
my plan is to press dry sleeves in the Buda engine with the same bore as the D262 and move over crank, pistons and all other parts. But my question is ,do the crank fit ? will the rods and pistons have the ringt lenght to the top of the engine block ?
The clearance must be right.
I hope for answers
Sorry for my bad English, Im from Sweden
Now i have find a Buda 273 with one broken piston and the cylinder head is broken.
The Buda 273 Engine block seems to be the same block as the D262 except the sleeves.
my plan is to press dry sleeves in the Buda engine with the same bore as the D262 and move over crank, pistons and all other parts. But my question is ,do the crank fit ? will the rods and pistons have the ringt lenght to the top of the engine block ?
The clearance must be right.
I hope for answers
Sorry for my bad English, Im from Sweden