While working on My distributor I noticed that the cap at the top sticks up above the distributor body.I just purchased a new cap and this one is the same, before I double gasket-ed, but found a small amount of dust when I was working on it this time.
Is there a fix for this or should I cut the front half of one of the gaskets off to make it level or machine some of the cap off, or?????? any one have the same problem. I also notice'd that the cavity in the coil for the condenser is not big enough. Thanks Duane.
Is there a fix for this or should I cut the front half of one of the gaskets off to make it level or machine some of the cap off, or?????? any one have the same problem. I also notice'd that the cavity in the coil for the condenser is not big enough. Thanks Duane.
