Draft control fighting my rear mount backhoe

[Fentenetty]

Just curious if there is a way to eliminate the draft
control on a mahindra 5530. I borrowed a rear
mount backhoe and while wrenching on a rock it
bucked and activated the draft control, now my lift
arms are fighting to raise the hoe and heating my
fluid up. Both the draft control and position levers
are down, but it?s still fighting itself. I have read that
some tractors have multiple holes at the top link
hookup but mine does not. Any ideas? Thanks.

 

[grizz02]

if the draft controls are all the way down the 3 point is in float , my NEW HOLLAND has a stop screw so to limit the lever going all the way down if you don't want it to, are you sure both levers are down post, pic of levers

 

[Fentenetty]

I?ll check again because it was dark last night, but I have had this piece of junk for 8 years and never had this problem before. I checked the manual and it does not offer any way to ?float? the rear arms. There is a isolator knob for long transports to eliminate the possibility of bumping the pc lever and dropping the implement. Never used it and not sure if this would also work backwards by not allowing arms to lift when the dc tries to raise them.