Drill sizes for taps

[Farmall MD nut]

I was goin thru some of my charts, and figured some of you can use this info on drill sizes for taps.




Thread-------Drill________Thread------------Drill

0-80---------3/64__________1/4-20-------------7
1-64---------53____________1/4-28-------------3
1-72---------53____________5/16-18------------F
2-56---------51____________5/16-24------------I
2-64---------50____________3/8-16------------5/16
3-48---------5/64__________3/8-24-------------Q
3-56---------46____________7/16-14------------U
4-40---------43____________7/16-20------------W
4-48---------42____________1/2-12-----------27/64
5-40---------39____________1/2-13-----------27/64
5-44---------37____________1/2-20-----------29/64
6-32---------36____________9/16-12----------31/64
6-40---------33____________9/16-18----------33/64
8-32---------29____________5/8-11-----------17/32
8-36---------29____________5/8-18-----------37/64
10-24--------25____________3/4-10-----------21/32
10-32--------21____________3/4-16-----------11/16
12-24--------17____________7/8-9------------49/64
12-28--------15____________7/8-14-----------13/16
1-8--------------7/8
1-12------------59/64
1-14 15/16

 

[Farmall MD nut]

Sorry for all the dashes and lines, but that's the only way it would format right. It won't let put spaces in between the numbers. Also, the 1-8, 1-12, and 1-14 should be below the 7/8, not the 12-28.
Hope you can make it out.
Doug

 

[Mike in Ohio]

Thaks alot I'm going to print this out and put copys with my taps and drills and drill press and every place else I can think of so I can find one of them next time I need it. Thanks again Mike

 

[williamf]

Thanks - That's a post that goes into my "How To - Mechanical" folder.
Wm