Dumb things you do

Charlie M

Well-known Member
I did one this week on my BN. I bought a used steering column to replace the beat one that came with the tractor. Thought it would be good to paint up the spots with no paint so they wouldn't rust. Now I can't shut off the tractor (its a mag) because there is no ground through the steering post due to the paint I put on. I knew that before and knew it after but didn't know it while putting on the steering column. Can't explain that. I tell people my moto is if a job is worth doing at all it worth doing at least twice.
 
I don't have any idea, but could you rig up s separate ground wire? That's be better anyway than grounding through rusty old frame joints.
 
I was moving the wheels in on my Ford 2000. Just from one side of the center to the other. Turned the center a little and something was holding it back on one side, valve stem. I got it in place reached down to put a bolt in and it was pissing fluid. New tube the next day.
 
I think this counts. Took dually to national forest to let dogs run. Department of Trees grading the road and adding new gravel. I started to pull out but dump truck arrived so I put it in reverse to back out of the way. Slight downhill grade. After he left I hit it kinda hard to get rolling. Forgot it was in reverse. In my defense it had been 30 sec. Missed the trees and buddies jeep.
 
Pretty much sums it up for me
cvphoto95934.jpg
 
I wonder how many here have very carefully driven a new seal into a hub while doing a brake job on a truck or trailer,then turning around to see the bearings still sitting on the bench.I recall doing it once,and I recall it very clearly.It was a $35.seal,and had to wait 12 hours to get another one.I had heard stories about doing it,and was always pretty carefull,but didn't really learn until I found just how stupid I could feel.
 
I switched some wheels and tires on my son's Impala. He didn't like that the TPMS indicated that the wrong tire was low on pressure. So I try ed three times to get the car to re learn the tire positions. Then he try ed. Then he asked me to help him do it. In the end, we figured out that the right front sensor was dead. It's a five minute job if they are all working properly, and you know what you are doing. Next time.
 
Years ago I did a tune up on my 3020lp I had at the time. When done it would not start. I literally moved the rotor bug out of my way to get on the tractor and try to start it. It fired up much better with all the parts in it. :oops:
 

Awhile back I was clearing out my shop, loaded up my truck with scrap steel. At the end of my driveway, as I stopped to turn onto the main road a broken table saw base came through my back window.

Wait, that's not the end of it!

A couple months later I was doing another clean-out. Threw a brake rotor into the truck, it hit something springy, popped up and....I can't even say it.

Anyway, I got good at replacing the rear window and the local salvage yard loves me.

Gerrit
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top