I thought I might try my luck in here as it’s been difficult to find information on. I have my grandpa’s ford 3000 that has a Dunham lehr loader on it. It does not have the support arms that hold the loader when mounting and dismounting. Does anyone have any pictures of what the pinned ends look like and general dimensions? I’d like to get the arms fabricated and replaced. Thanks
Destroked 450
Well-known Member
- Location
- Harned, Ky
I’ve got 3 of those loaders and one set of parking stands, I need to pull them off to make more
At present the loader is off so not sure if I can get the measurements you need but I’ll try to get some photos and measurements
I did that for someone else but that phone got destroyed and several photos were lost
It’ll be tomorrow before I can mess with it
At present the loader is off so not sure if I can get the measurements you need but I’ll try to get some photos and measurements
I did that for someone else but that phone got destroyed and several photos were lost
It’ll be tomorrow before I can mess with it
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy