Wanting to convert my JD 1010 to electronic ignition. It has WICO B Model X30091F dizzy and Pertronix conversion kit is WO141 which I purchased.
I have a photo of WO141 Pertronix ignition conversion mounting plate but can't post it. Dimensions show there is a difference of about .250 inches rendering it un-installable. One of the holes is partially under the sensor and had to be pushed under it with a small piece broken from it.
Obviously it doesn't fit. It's the weekend so Pertronix is unavailable for questions.
My question is: Does anyone have access to a WO141 plate to verify hole distance? wondering if this is wrong plate or just not machined properly.
I have a photo of WO141 Pertronix ignition conversion mounting plate but can't post it. Dimensions show there is a difference of about .250 inches rendering it un-installable. One of the holes is partially under the sensor and had to be pushed under it with a small piece broken from it.
Obviously it doesn't fit. It's the weekend so Pertronix is unavailable for questions.
My question is: Does anyone have access to a WO141 plate to verify hole distance? wondering if this is wrong plate or just not machined properly.
