G
guido
Guest
Hello fellows wrench turners!
I just wanted to pass this on.
A friend of mine bought a MM to use as a puller.
When we went to adjust the valves, #3 intake had very little cam movement, and the adjusting screw was all the way up.There was a 3/8' bolt and lock washer under the push rod on top of the lifter! It ran the week end before at the pulls in 2 classes and made full pulls in both! My respect to MM !!!!!!!!!.
Any body out there found things inside of an engine that did not belonge?
Guido.
I just wanted to pass this on.
A friend of mine bought a MM to use as a puller.
When we went to adjust the valves, #3 intake had very little cam movement, and the adjusting screw was all the way up.There was a 3/8' bolt and lock washer under the push rod on top of the lifter! It ran the week end before at the pulls in 2 classes and made full pulls in both! My respect to MM !!!!!!!!!.
Any body out there found things inside of an engine that did not belonge?
Guido.