Engine Size?

[Hoedown]

How can I tell what size gas engine my 64 530CK has in it. And where to get an upper gasket kit for it?
Thanks, Hoedown

 

[mEl]

The common engine size for a 530 gas is 159 CID. There may be a tag just ahead of the starter down along the pan flange with the info you need on it.

 

[Hoedown]

The tag on the block says its a G201A, #2620094 Anyone know where I can get a intake and exhaust gasket?
I could use a new intake and exhaust manifold as well. Someone welded it and did not do a good job.
Any help would be great.
Thanks, Hoedown

 

[jon f mn]

John saeli at external_link in new York should be able to fix you up.

 

[mEl]

The tag on the block says its a G201A, #2620094 Anyone know where I can get a intake and exhaust gasket?
I could use a new intake and exhaust manifold as well. Someone welded it and did not do a good job.
Any help would be great.
Thanks, Hoedown

The 201 was used in combine applications, so I'm betting someone has done a transplant, the 201s are somewhat hard to find parts for. I have seen some complete engines pop up on Facebook Messenger, some pretty reasonable.

 

[Hoedown]

Can anyone tell me if the intake manifold off a 159 will fit my 201?
Help? Anyone?
Thanks, Hoedown

 

[John Saeli]

Can anyone tell me if the intake manifold off a 159 will fit my 201?
Help? Anyone?
Thanks, Hoedown

Not even close.

 

[Hoedown]

Not even close.

First off, I don't know anything about tractors. This is the first backhoe I've owned and there is no telling what's been done to it since 1964. I thought it was a 159 but the tag on the block says "G201 A". What I have looks the same as a 159. How are they different? All I need is a intake and exhaust gasket. I was going to replace both manifolds because someone has welded them and did not do a very good job. Any help is appreciated.
Thanks, Hoedown

 

[John Saeli]

First off, I don't know anything about tractors. This is the first backhoe I've owned and there is no telling what's been done to it since 1964. I thought it was a 159 but the tag on the block says "G201 A". What I have looks the same as a 159. How are they different? All I need is a intake and exhaust gasket. I was going to replace both manifolds because someone has welded them and did not do a very good job. Any help is appreciated.
Thanks, Hoedown

If you measure the straight line distance from the very left hand manifold mounting stud to the very right hand stud, the 159 is 15-3/4". The 201 is 18-3/4". We stock both gaskets. 315-585-9826