Farmall 1066 seat

[flhr62]

Not a very good picture of the seat bottom,but it is the three piece set for that tractor. Can't figure out how it mounts to the tractor. Am I missing something?

 

[hydro70guy]

I think the old seat should have had a couple question mark shaped pieces that bolt to bottom of seat an fit around tube frame around
back of seat. Then I am pretty sure they can allow seat to tip back. They would be easy to make.

 

[steve706]

Hydro70guy is correct, but the tube is shot, need to replace it or risk a nasty accident.

 

[flhr62]

My plan is to cut out bad pieces of tubing and weld new pieces in

 

[mazemeister]

those brackets bolt to front of seat, back should have a little clip in the middle, so the seat tips forward.

 

[steve706]

They are just called clamps, CaseIH p/n# 379321R1

 

[flhr62]

Thanks for the help and the P/N. I appreciate it.

Thanks again
Mark