Farmall 200 Engine Block

[Bohemian32]

I found the front casting, but now I am in need of a engine block.
I took mine to Rex in Cambridge IA and after he looked at it suggested that I try to find a good used one.
Anybody have any thoughts
or have one that they might consider parting with.

 

[Bohemian32]

i made some calls and found one in Worthington MN,
All is well They guaranteed to be good.

 

[fastfarmall]

Thats a good yard

 

[Dennis K (WA)]

Just make sure what they are sending can accommodate your hydraulic pump. Older engines in the A's and B's did not.
Just a thought.
Dennis

 

[gene bender]

You did give them the measurement of your sleeve at the bottom where the o-ring goes after all the yrs to have the correct
block for that measurement because you never know till a sleeve is pulled and measured there

 

[riverbend]

Was the problem cracks in the deck, running between the bolt holes and the cylinders ?
Greg

 

[Bohemian32]

The problem was between two of the water ports and the cyliner bore
Both sides of the number three hole about .020 space between
sleve and block wall