Farmall 230 Carb problem

wolfman

Well-known Member
Pretty sure it is a carb problem. Parked the Farmall 230 the other day and heard what sounded like water running onto the floor. Gas was running out of the carb. Tapped it with rubber hammer, etc. Restarted it, it was flooded. Turned gas off at sediment bowl. Couple days later, it started, ran a while & then stalled out. Gas not running out now but it doesn't want to start. Maybe carb cleaner??? Suggestions.
 
It sounds like a needle and seat problem or a float issue. Buy a carb kit and clean/rebuild it. Make sure when you disassemble it that you check the float for any pin holes that will cause it to sink to the bottom of the bowl and continually let fuel into the carb. I have also seen the needle valve wear a groove in the float where it contacts. If this is the case the needle can get wedged inside the seat and not close the orifice properly. If thats the case I would wrap sand paper around a small file and smooth the groove out. Make sure to properly adjust you float before you reassemble. Best of luck.

Matt
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top