Farmall 300 governor

Stratton21

New User
I have a farmall 300 that I believe has a governor problem. When the tractor is under a load it doesn't catch up/ or send more fuel. The engine just stays bogged down. Also the tractor idles but I have to crank the throttle more than half way to get the engine speed to increase. Once it's revved up it doesn't want to go all the way to idle speed. I adjusted to governor according to the manual and I believe everything is hooked up right. Just need to know what's going on and how I might fix it.

Thanks
 
Just a guess, but could be your pins in the weights are worn, my smta acted a lot like that. Is it getting oil in the Governor?
 
Binding of the linkage is often one of the issues. With the linkage removed from the governor arm (back side of governor) and the wheels blocked or good brakes locked, move the governor control arm through its travel if it is free to move through its range, try it with the engine running. If the lever does nothing for a portion of its travel, that is pretty normal for IH governors. but from the point that resistance to movement begins, the engine should speed up progressively and in a linear fashion till the lever is against its stop; and the engine is at rated high Idle (not load RPM). It should also idle down in the same linear manor to engine idle, till it again moves with no further change. If this is the way yours works, the governor is working properly. Engine lugging and poor output may be due to advance issues, initial timing issues, or fuel delivery. If the linkage is binding from the lever to the governor arm, it needs to be looked at, and serviced. The sheet metal may need to be removed to access several troublesome pivots and springs. You will find the throttle lever tohave a range of doing nothing from the farthest idle position of the lever notches to at least one quarter of the travel, and sometimes 40 % of travel. if the lever moves the governor arm fully when the hand lever is in the bottom notch, it is OK. Jim
 
It could be some one had the carb. off and didn't get the tang on the governor shaft in the right notch in the carb, just fixed one last week for a guy who had same symtoms. Pete
 
I never did the advance timing on this tractor because I never knew how. I have a manual now but never thought about advance timing. I'll give it a shot and see what happens. Thanks for the information.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top