(800) 853-2651
SHOP NOW

Farmall 504

Yesterday's Tractor Forums
I don't think so. I have seen flat top fenders from a Oliver tractor retrofitted to a 544 though, so I'm sure something can be made to fit a 504.
 
Could put some from one of the 06,56,66 series on it just redrill the holes if they need to be for a square axle versus the hexagon axle housing. Would bolt on and then could be adjusted for the tire size afterwards.
 
There WERE flat top fenders available for the Farmall model.

The fenders themselves are the same as 706/806 fenders, but the mounts are different. On the 504 they bolt into the top of the axle with four 1/2" bolts, vs the others which clamp around the hexagonal axle.

Flat top fenders from a 544, 656, 666, or 686 will have the same mounting.

Where to find? You can get reproduction fenders and brackets from 100's of vendors online. The base plate does not seem to be available, but it is not terribly difficult to make.

mvphoto108562.jpg
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top