Farmall h project

[michiganmilkman]

Just a little project I'm working on. Open to ideas and criticism. Thanks Rob

[/img:abf5c73c05]

 

[Janicholson]

That will be fine. I would block it up far enough to allow the tires to be moved in to within 2 inches of the sides. Might be level with the platform. I would make the entire cam removable upwards with no more than about 6 bolts. I would mount the heater core/blower under the gas tank and on the cab side of the partition used to close off the front of the cab at the rear edge of the pulley gear box. That way the hoses could remain attached if the cab were removed.
Electricity for lights and GPS and the computer integrated steering should be plug and play from the power at the bulkhead. Kinda tongue in cheek there. Jim

 

[caterpillar guy]

We have a cab like that on a 1466 noisy thing like an echo chamber in it. 3 Pt levers make the most noise and loud. Looks good the H just will weigh almost as much as the tractor, kidding. I would also set it so I could move the tires in to at least the 30inch row setting which is 60inch centers. The floor should set level with the platform or a bit higher if needed to clear the tires. Otherwise it looks good there.

 

[rustred]

first time a saw a cab added to an old tractor that looks good and suits the tractor!

 

[matthies]

If you would put canvas along the engine and into the cab, the engine fan would warm that up nicely. Does just fine with a heat houser on mine.

 

[AL Moyer]

My first thought, how/ where do you plan on getting in to it, seems like might be a bit difficult, but never used a tractor with a cab !, shame it's so tall, makes it look top heavy, but still quite a neat project ! AL