Fast Hitch Post Hole Digger

[Bookman]

I have had this two point post hole digger for about ten years. At one time I thought it was made by Kim Manufacturing of Kansas City, but I can find no information about them. I am missing part of the PTO
shaft. Any ideas where I can get one? If I have one made, any thing I need to know about aligning up the shafts, etc. It is not for sale. I have a pto shaft from another implement I can use on the post
hole digger. Any ideas as to a protective shield too? Thanks in advance.

https://www.yesterdaystractors.com/cvphotos/cvphoto90015.j
<img src=https://www.yesterdaystractors.com/cvphotos/cvphoto90016.jpg

 

[DeltaRed]

It's just a standard light duty shaft.Nothing special or 'proprietary'
Any implement dealer,some farm stores will have the parts on the shelf.Same thing with the gaurd.

 

[Bookman]

Thanks much. Good to know. I will check the local TSC and then Case-IH dealer

 

[BarnyardEngineering]

Just be prepared for some sticker shock. New PTO shafts are not cheap.

Pull the half off the gearbox and see what kind of connection it is there. You'll need to know that if you're buying the entire new shaft.

 

[Lucid]

I have a question about the points. Are they just fit in those channels and welded in or bolted? Also looks like they have a bend in em.

 

[Bookman]

They are welded in. They have a slight bend. Hope this is helpful.

 

[Bookman]

Thanks, I am showing the half that connects to the gear box. I need the part that connects to the pto shaft of the tractor. Yep, perused the TSC site, and there may be sticker shock involved, which is why
I want to get it right the first time. Thanks

 

[Lucid]

Thanks, yes was helpful!