ford 2000 intermittent lifting

66 ford

New User
Hello, i have a 66 Ford 2000 3 cyl diesel. I have this lifting problem where it lifts fine and then all of the sudden it does not want to lift for a few minutes. If i increase RPMs most of the time is will come right up. When it does lift it is very strong and will stay up. so i have deduced from researching this forum and other places that the culprit is probably my unload valve getting stuck. Here it is. Before i removed it i checked to see that it was moving freely and it was maybe a little more than i expected. the only thing i see wrong is this terrible o ring. is it possible that its not sealing good enough and not getting enough pressure to slide it? just trying to make sure this is what the problem is before i put it back together. Everything else i have checked looks good.
 
It looks like my picture did not come through, but in case i dont figure out what im doing wrong on the picture posting. The o ring looks like it is chewed up a bit around the edges like it has been getting some wear from something.
 
You may be aware or not, but there are 2 filters (inflow and output) in the hydraulic sump. One of them is a paper cartridge
encased in a steel mesh. PIB to service so a lot of them never were.
 
(quoted from post at 16:10:15 08/04/20) Hello, i have a 66 Ford 2000 3 cyl diesel. I have this lifting problem where it lifts fine and then all of the sudden it does not want to lift for a few minutes. If i increase RPMs most of the time is will come right up. When it does lift it is very strong and will stay up. so i have deduced from researching this forum and other places that the culprit is probably my unload valve getting stuck. Here it is. Before i removed it i checked to see that it was moving freely and it was maybe a little more than i expected. the only thing i see wrong is this terrible o ring. is it possible that its not sealing good enough and not getting enough pressure to slide it? just trying to make sure this is what the problem is before i put it back together. Everything else i have checked looks good.

Did you check the fluid level before you started taking things apart? Always check the simple things first.
 
(quoted from post at 09:00:24 08/06/20) You may be aware or not, but there are 2 filters (inflow and output) in the hydraulic sump. One of them is a paper cartridge
encased in a steel mesh. PIB to service so a lot of them never were.

The intake "filter" is a metal screen on the end of the pickup tube. It is meant to be cleaned and re-used. The return filter is a cartridge type that is meant to be replaced, but as you said it is a pain to get to so they usually don't get replaced, but there is a bypass valve that opens up if the return filter gets clogged, so it is usually not a problem.
 



just guessing... hyd pump needs to be rebuilt. sometimes it sucks and some times it looses prime and doesnt suck...

reving it up a bit helps a worn pump pick up fluid better.

Might try a pressure gauge or a rebuild kit.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top