I have a 1970 3000 diesel. I think it's on the changeover from pre force to force because it's got force tinwork, but a smaller pre force front axle.
I removed the front pivot, spacer and bushing because it was badly worn, but can't seem to find the correct replacement set.
I orderred a new pin and bush, but they couldn't supply the spacer. The new bush is totally different to what came out. My existing setup is the earlier style pin which goes through a sleeve/spacer (item 26), the sleeve then slides through the bushing (item 21), which is considderably thinner than the new one thats come.
This is a picture of what mine should look like, but this is the only one I've found, on ebay in the USA. Any UK based companies sell this? Or anyone else have the same setup?
I removed the front pivot, spacer and bushing because it was badly worn, but can't seem to find the correct replacement set.
I orderred a new pin and bush, but they couldn't supply the spacer. The new bush is totally different to what came out. My existing setup is the earlier style pin which goes through a sleeve/spacer (item 26), the sleeve then slides through the bushing (item 21), which is considderably thinner than the new one thats come.
This is a picture of what mine should look like, but this is the only one I've found, on ebay in the USA. Any UK based companies sell this? Or anyone else have the same setup?
