DY

Member
Is there any unique problems with a Ford 5000 gas? There is one for sale locally but I don't know anything about this model. Were they made in Mexico? Id it hard to get parts. How does the gear shift select different gears. The ad had very little information but said that it has an automatic transmission.
 
Great tractor. All of mine have bee ndiesel so I can't comment on the gas engine. You are looking at a 10 speed Select-O-Speed transmission. Parts are difficult to obtain (expect no dealer support) but not impossible to find via the Web. finding someone to work on them is a challenge though there are several compotent folks on the Ford board found below. Shift it through each gear, check the PTO (brake should stop the shaft when the PTO is off). Ask more questions after you take it for a spin. I've owned three 5000's and two 4000's with the SOS transmission and love it for my hay work. Good luck!
 
Sounds like a pre 1975 model with a Select-O-Speed transmission. It would have 10 forward gears and 2 reverse. Basically, depress the left pedal, shift into 1st, then upshift and downshift on the fly. More or less a powershift transmission. If it is currently running and operating, depending on what the seller is asking, might be a decent buy. Most would tell you to run from it, and that may be a good idea if it has transmission problems. Parts for this transmission may be a challenge at this point, however there are enough of them still out there, hard to say what will or will not show up, NOS, used, salvage etc.

You must have the correct manual(s) to work on these, and there is a lot to know about them. Always use the specified fluid and or equivalent in these transmissions.

I ran a 4000 S-O-S for many years doing all the work we needed a tractor for, was a great tractor and though some were a bit jerky, this one was mild, some gears did seem to do that more than not, been a long time since I ran one of these though. I'm still a fan as they have a gear for every task, easy to drive and or teach someone to drive.

One in good operating order may serve you well for many years with decent maintenance, and care. The Ford 5000 was a well regarded tractor otherwise, we sold them new and sold a fair amount of them. I remember a trade in 5000, we field tested while baling hay, sure seemed like a good one then, that one had the 8 speed transmission.
 
I will put in my 2 cents. I have a 1974 Ford 5000 diesel 8spd. They are bulletproof old tractors. It is very good on fuel. The gas 5000 likes it's fuel. I for one would not own a Select-O-Speed because of parts availability, they are not easy to fix unless you know a lot about them and finding someone that does is not easy and if you do chances are they are not close to you. They are complicated transmission unless like I said you know a lot about them. I don't think they are for a novice mechanic. I am not a mechanic by any means but would not hesitate to dive in fixing anything on my 5000 diesel 8spd.
 
Assuming it is that SelectoSpeed transmission, they were pretty much the first power shift tranny.

If its working, great. They were a fairly handy good tranny.

But, they do wear out, and when they do there are 3 separate clutches, and extra parts, in there. They can turn into a money pit when they break. Not as many experienced mechanics with them any more, and some parts are getting hard to find.

So, not scaring you away but do check out that tranny that it is in good shape. Generally an SoS brings less money at a sale, because buyers are scared its bad and expensive to fix.

Paul
 
The 5000s were/are one of the most bullet proof old tractors ever built by any brand or color. That said, a 5000 gas, Select O Speed model is, by far, the least desirable of them. I could live with a gas engine but do not like that transmission.
Had one in a 4000 for a while and will never own another.
 
Thanks everyone! I will test drive it this weekend. P.S. The owner said that there is a slight pan leak. I would assume that this would be an easy fix.
 

If hes talking about the engine oil pan then no it is not a easy fix
The oil pan is cast and quite heavy, the front axle also pins to the oil pan requiring it and the front bolster being removed in order to get the oil pan off
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top