Ford 850 Tractor

Kellar

New User
I have a 850 Ford Tractor. I know the firing order is 1243 but where is #1 on the cap? Does it matter?
Is it on one side of the dist clip? Thanks

Lee
 
Lee:

The location of the #1 cylinder plug wire in the cap will depend upon how your distributor is installed.

Dean
 
It doesn't matter which nipple the #1 plug wire is attached to as long as the rotor is lined up with that nipple with the #1 piston at TDC on the compression stroke.
 
When you get the #1 piston at TDC on the fire stroke, have a look see where the rotor is pointing.

It honestly can be done at any notch on the gears.
 

Remove the #1 spark plug. Stick a finger in the spark plug hole. Turn the ignition OFF. Bump the starter until you feel compression try to blow your finger out of the hole. Finish turning the engine in the direction of rotation. (clockwise) until the timing mark on the flywheel is on TDC. Look at the distributor cap and find where it is marked #1. Drop the distributor into the hole and try to make the rotor point to the #1 position on the cap. Marking the distributor with a white out pen to where the #1 on the cap is will help or use your imagination.


With the rotor pointing to the #1 on the distributor cap turn the distributor while observing the points. when the points just open lock the distributor down and replace the cap and try to start her. If it doesn't seem just right in time you can move the distributor right or left till the engine sounds like it is running easiest.

Like tuning a piano or guitar!


put the other plug wires into the cap in firing order in the direction of rotation of the rotor. On the 8N it is counter clock wise. Can't remember about the 134 engines.???
Zane
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top