ford 8n

[tomTowers]

I have not ben succsesfull in getting the hub off of the rear axle, what have you-all used to revove them?
Tom towers 931 788 6092 if you wish to call

 

[Dave83]

Most of the comments I've read on the N-forum tell you to loosen the nut a few threads and run the tractor around in quick figure 8 turns to loosen them up. Never tried it, but sounds like it will work. May take some time.

 

[Dean]

Do as Dave advises.

Loosen the nut about 2 or 3 turns and drive the tractor around until the hub pops loose.

Be sure to torque the nut to 450 lbs/ft upon reassembly.

Dean