Ford brakes

Don't know your resources. I have resources like a jack, hammer, torch, impact wrench, crow bar, a 2x4 block of wood for use with the crowbar to work the tire off (keep it vertical when off if working alone) a quality penetrating oil. Biggest problem is getting the wheel off the hub....cast iron so you have to be easy beating on it so you don't crack it. Heat has to be used sparingly since there is an axle oil seal on the other side of the backing plate .

I made a puller. Basically cut and welded a piece of square tubing into a U shape. Cut slits in it where it could slide over the 1/2 or so (wide)brake drum reinforcing strips around the outside of the drum. Then had holes in the cross bar section that slid down over the lug studs. I put a lug nut on each of the 2 opposing studs I used, then slid the puller over the studs and down onto the nuts. Backing the nuts off the studs against the puller gave me my needed removal force. I have a couple of pictures around somewhere but getting them and on here don't know.

Since you have no brakes you don't need to back off the star on the adjuster, as you know, accessible through the hole in the backing plate. I'd clean up the plate with a wire wheel, so that the shoe can slide easily, wire clean and oil the adjuster screw threads, replace the springs, new shoes...be sure to get the ones for that tractor, have the drums turned for better initial seating. I had a home owned auto parts store available that catered to the N and later rebuilders in the area. He had parts, turning machine, everything. Nice.

Good luck.
 
5000 has inboard brakes. First thing to do is try to adjust the brake. Rod in front of axle housing under the footstep. Takes two open end wrenches. You may have adjustment left to get the petal up. If not you will have to remove the housing to replace the internal brake disc and related parts.
 
Texasmark is describing the N series OUTboard brakes.

A 5000 has inboard brakes, and disc brakes for that matter. Part #29 is your brake, and everything from #9 in has to come off to get to it.

mvphoto75275.png
 
Wow, thanks for the detailed instructions! I am old and gimpy so I will try to find a Ford tractor Mechanic in Southern Illinois. Again, thanks for your replies.
 

Looks like another fine example of Fix Or Repair Daily engineering. Edsel must have been involved in that.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top