Front end rebuild.

[DeltaRed]

I have a wide front from an 806. All the bushings are shot(or gone).The spindles werevwelded to the arms. Where can I get bushings/bearings to rebuild this. Wanting to put it on my loader tractor. Thanks. Steve.

 

[Janicholson]

I have a wide front from an 806. All the bushings are shot(or gone).The spindles werevwelded to the arms. Where can I get bushings/bearings to rebuild this. Wanting to put it on my loader tractor. Thanks. Steve.

National Bronze
The bushings (if not from IH) can be found from suppliers like Motion Industries, or the link provided. Most will be to standard sizes on OD. some may be as needed but longer or shorter, No issue there, just use 2 instead of one.
The thrust bearing will be needing replaced as well It is likely a thrust ball bearing with a bearing number. Jim

 

[caterpillar guy]

I bought a set of bushings and pivot pin for my 806 From All State Ag parts the hose here. I talked to All State directly. It even had the felt washers for it. Kit has 4 bushings 2 thrust bearings and felt. Pivot has the shaft and bushings I have had it for a couple years now and not in yet. I also drill the stay ball casting so I can grease it while apart too.

 

[Fritz Maurer]

If you have been running with missing bushings, there is probably no place to put the new bushings. Better disassemble and inspect the tube before ordering parts.

 

[DeltaRed]

If you have been running with missing bushings, there is probably no place to put the new bushings. Better disassemble and inspect the tube before ordering parts.

I have never had this front installed. It came on a junk/parts tractor I bought several years ago.