frozen motor

[mike delaney]

I've been using tranny fluid in the cylinders like some of you suggested. I'm going to go out and try to rock it in 4Th gear to see if it's gotten loose. If I have no luck should I leave it or try something else? All you input is greatly appreciated. Mike

 

[john_Bud]

Time is one of your greatest allies in the struggle, I'd give it time.

 

[old]

On ALL the engines I have freed up I set a 12 volt battery on them and then use short fast taps of the starter button with the plugs out. But I also do not pull the plugs till I see the crank pulley move a little bit. Reason is if it moves just a little bit with the plugs still in that in turn forces the ATF down with high pressure so that in tun helps free it up. If the crank pulley moves just a little bit then I pull the plugs and try again and most times you end up with a big mess of ATF spraying all over the place

 

[Jr in nwmo]

Take the starter off and stick a bar on the ring gear and try to turn her you have a lot of power there good luck