fuel gauge test 7700

i think the gage is stuck or is junk. mine is like that to and it dont even have a battery in it and the bottom tank is off because we have to spit it for the clutch and trans
 
You've probably got a bare wire to the sender somewhere... or a shorted sender. Those gauges operate on the principle of 12V into the gauge with a variable ground path at the sender. The sender should give a high resistance at empty and no resistance at full... thus it gets full ground with a full tank...
Short story. If you ground the sender wire the gauge will read full. With the wire unhooked it will likely float somewhere between empty and full.
So check your wires...

Rod
 
The wires checked ok, the sender measered open and i know the tank is over half full.

I will try the test on the gauge, dont want to run dry, would be nice to get at least that bottom tank working, as i understand the top tank drains into the bottom.
 
Sender should not measure open at any time. Pull the wire off and ground it; see what the gauge does. If it sweeps normally and pegs full, replace the sender.

Rod
 
the 7700 is a floating gauge and will not necessarily return to cold or hot. This does not mean that it is bad. However this model dash has a foil on plastic board on the back of the instrument panel that can be a bit problematic. Check all wires for continuity. Measure sender units. I dont remember the exact resistance but I think they should measure between 25 ohms and 200 ohms if they are working correctly. If you can read these mesurements and then read them again at the switch on the dash that changes the gauge from top tank to bottom tank, then look at your instrument panel for problems. especially the plug on the back of the gauge panel can be dirty. also the passthrough connector at the floor board is usually bad about coording and the black plastic connector will crumble due to age and heat. you can just pull each connector out on both side and then plug them back in and put heat shrink tubing around them. Have done this many times on this series, but the colors of the wires on one side dont alway match the color of the wire going out the other. Once this plug acts up, you will need to pull the wires one by one on both sides and bypass the plastic and you will be good for another 40 years or so.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top