G tool rods

[SMITTY 77]

Lookin for info from pulers using rods built by g tool pros and cons.

 

[M.Genrich]

I have put a couple sets in customers tractors and have been very happy with them. They were narrow on the big end and cleared the block with minimal grinding. Nice clean strong rods. They were a little on the heavy side but at 30% over factory high idle I don't figure that much matters. I would recommend them.

 

[southpull]

what he said ^^^. we're not turning enough rpms for the weight to matter, and those g tool rods are as nice and tough as they get.