Gasket cement

jimlll

Member
I need to replace the crankcase/oil pan gasket on a vertical shaft B&S vanguard engine.
Copper coat was a good cement but I have not seen it in years.
 
Copper coat is certainly available every where in St. Cloud's Auto stores. Hy-Tac spray or brush helps hold gaskets in place and works very well. Follow the directions and the gasket will stick in place. (use on one side only) flatten the bolt holes in the pan on a flat surface to assure good seal. Tighten each bolt to eliminate all slack, then turn each bolt 1 turn. This prevents bent pans, and smishes the gasket uniformly. Jim
 
You can use anaerobic sealant on 2 mating, machined surfaces. On some oil pans and valve covers, you can use Permatex gasket maker: silicone. Mark.
 

The gasket is the problem it will slip out. If you feel the need to gasket it back glue the gasket good on one side. I don't use a gasket I use good RTV none have came back : )..

If you use RTV assy the cover with no gasket check that you still have crankshaft endplay if so get it good and clean apply a small bead of permatex ultra grey RTV it will be set for life...
 
I had one of those fine Olds 307 engines that they saved using four bolts on the ends of the intake manafold and it started leaking coolant. I used copper coat on the replacement intake gasket and never had another leak until my notso fine Credit Union decided they wanted the car.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top