Generation disassembly

How do you remove the copper assembly to
get to the bearing
cvphoto117833.jpg
 
I'd say the first step would be to clean all of the crud off with a wire brush or wheel so you can see what you are working on. It looks like there are 3 small screws holding the end plate on, take them out and see what's behind it. Clean up the shaft and lube it and it should slide in thru the housing. Probably have to kiss it with a hammer a few times.
 
(quoted from post at 02:22:37 02/18/22) How do you remove the copper assembly to
get to the bearing
<img src=https://www.yesterdaystractors.com/cvphotos/cvphoto117833.jpg>

Pressing the shaft out of the bearing is the preferred method.

Certainly do not hit the shaft with a hammer - use a soft mallet to prevent damaging the shaft, if you go that way.
 
(quoted from post at 14:40:22 02/20/22) Or leave the nut on flush. Also keeps the armature from hitting the floor.

Noo! May still damage the threads, likely brinell the bearing races or leave divots in them. Not a good plan. - maybe used by a fitter, but not by an engineer.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top