Gleaner E corn settings

Marcus

Member
I have Gleaner E that I will be using to harvest corn with for the first time. I have a users manual for both the combine and corn head but neither one mentions setting up the shoe for corn or how much air to put on. The only thing it mentions is cylinder clearance,removing the even number concaves, moving the straw walkers back. Can anyone help with some general setting to start from?
 
In corn I"ve always run the air on my Gleaners wide open. Small grain is smaller and blows out easier. Beans about 2/3- 3/4 open. Try setting the chaffer at 5/8 inch, 3/4 inch at most. Set the sieve a bit larger than the kernels, maybe 3/8 inch.
 
Also slow the cylinder down. Should be at almost the slowest setting unles the corn will be over 25% moisture, then you may have to increase it a bit.
 
What jon says about cyl speed is right- corn, start at low end, about 500 rpm. With most Gleaners of that era, you have lg and small cyl pulleys, different belts. Small pulley, about 8 inches, is for small grain. lgr, about 12-15 inches, is for corn/soy. If you have AC op manual, the settings for chaffer, sieve, cyl speed, concaves, etc. will be in there. Devour the book! Enjoy- always fun to see the harvest come in.
 
Thanks for the help. I have a large sprocket for the cylinder that should put it at 500 rpms and also have to put in the filler bars. The shoe settings were the only thing I couldn't find in the manual. Thanks again and will try to post some picures of harvest. Its just a little over a month away for us.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top