Governor to Carb

[Brent 41 9N]

Hey guys,
I have a 1941 9N. When I got it there was a considerable amount of rigging done, one being the linkage from the carb to the governor. Yesterday, while clearing sone small trees, The motor started racing. I found that the above mentioned rigging had fallen apart. It was tied with some wire, and I have no idea which linkage arm goes where on the carb. Does anyone have a diagram?
Please Help, Thanks

 

[HCooke]

This diagram from the CNH web site shows the two rods connected to the gov. They are avail new. Hard to mix up because the ball ends are of different size.

 

[JMOR]

(quoted from post at 08:42:08 02/28/10) Hey guys,
I have a 1941 9N. When I got it there was a considerable amount of rigging done, one being the linkage from the carb to the governor. Yesterday, while clearing sone small trees, The motor started racing. I found that the above mentioned rigging had fallen apart. It was tied with some wire, and I have no idea which linkage arm goes where on the carb. Does anyone have a diagram?
Please Help, Thanks

closest to engine block goes to carb.

 

[Brent 41 9N]

Thanks,
Went out and hooked back up, without so much rigging. Runs great, will order both new rods(ends broken) along with about a hundred other incorrect parts this week.
Thanks again