Hi All, I have been a very long time follower of this site and appreciate all the info this forum has to offer.
I have a 1964 Ford 4000 Industrial with front end loader.
When I bought it, I flushed the tank, installed a new petcock and carburetor. She has been running great for about a year now and finally decided to stump me a little. When shredding for a while, she starts to jerk and stumble as though being starved for fuel If I pump the throttle a bit she will smooth out for about 100 yards then stumble and quit. She starts right up after a cooling period and works great for another 10 minutes and then quits again.
I have done the following : Checked the water,(Full and not hot enough to overheat) , wrapped my fuel line with foil in-case of vapor lock , installed a new 12 volt coil , check distributor,rotor and plugs and wires. Flow from gas tank is clean and free. When she runs there are no issues until she gets warm.
Any comments and thoughts will be greatly appreciated.
Thanks
I have a 1964 Ford 4000 Industrial with front end loader.
When I bought it, I flushed the tank, installed a new petcock and carburetor. She has been running great for about a year now and finally decided to stump me a little. When shredding for a while, she starts to jerk and stumble as though being starved for fuel If I pump the throttle a bit she will smooth out for about 100 yards then stumble and quit. She starts right up after a cooling period and works great for another 10 minutes and then quits again.
I have done the following : Checked the water,(Full and not hot enough to overheat) , wrapped my fuel line with foil in-case of vapor lock , installed a new 12 volt coil , check distributor,rotor and plugs and wires. Flow from gas tank is clean and free. When she runs there are no issues until she gets warm.
Any comments and thoughts will be greatly appreciated.
Thanks